 |
|
 |
MUSTANG GT DUAL FUEL PUMP KIT
M-9407-GT05 $780.00 
• Fits 2005-2009 Mustang GT
• Includes harness, dual fuel pumps, drop in housing and fuel pump driver module from the 2007-08 Shelby GT500
• Includes all installation hardware
• Highly recommended for any application making over 400 hp
• Same fuel pump kit as used in the 2007-08 Shelby GT500 |
|
|
|
|
2010 MUSTANG GT DUAL FUEL PUMP KIT
M-9407-MSVTA $780.00
• Fits 2010 Mustang GT
• Includes harness, dual fuel pumps, drop in housing
and fuel pump driver module from the
2010 SVT Mustang
• Includes all installation hardware
• Highly recommended for any application making over 400 hp |
|
|
|
 |
FUEL INJECTORS
M-9593-LU24 - 24LBS/HR $189.00 Set of 8
M-9593-LU34 - 34LBS/HR $299.00 Set of 8
M-9593-M39 - 39LBS/HR $395.00 Set of 8
M-9593-LU60 - 60LBS/HR $430.00 Set of 8 |
|
|
|
 |
FORD RACING 80 LB/HR FUEL
INJECTOR SET
M-9593-LU80 -
80LBS/HR $460.00 Set of 8
|
|
|
|
 |
FUEL RAILS
4001031 - 2005-08 5/8” 4.6L MUSTANG RETURN TYPE $434.95
4001032 - 2005-08 5/8” 4.6L 3V MUSTANG RETURN-LESS
TYPE $434.95
Billet fuel rails provide increased fuel flow an a better balance to each cylinder.
The rails are specifically made to fit as a bolt-on for the Ford 4.6 3V engines.
The rails fit all common injector sizes. Blue anodized finish. |
|
|
|
 |
HIGH VELOCITY COLD AIR KIT AND SCT PROGRAMMER
555-3131-KIT $819.95
Testing has shown increases of up to 38 HP and 30ft lbs of Torque to the rear wheels with this Cold Air Kit and high flow elbow combined with SCT Tune.
Comes complete with a lifetime filter can be cleaned and re-oiled. |
|
|
 |
90MM COLD AIR KIT WITH PROGRAMMER
M-9603-GTB $669.00
• Fits 2005-10 Mustang GT Manual or Automatic transmission
• Kit includes 90mm aluminum mass air meter and Pro-Cal tool
• Approximate increase of 20 horsepower |
|
|
 |
FORD BLASTER COIL-ON-PLUG
82438 $434.95
The new Blaster CoPs are designed as a direct bolt-in replacement coil for 4.6L 3V.
Highly recommended for supercharged, turbocharged, and nitrous
applications. |
|
|
 |
AUTOLITE HT SPARK PLUGS
HT0 $14.95ea
Designed for use with supercharged, turbocharged and nitrous applications, this spark plug is one heat range colder than the stock Mustang GT |
|
|
 |
2005-2010 MUSTANG GT BILLET THROTTLE BODY
M-9926-3V* $559.95
• Fits in factory location on 2005-2010 Mustang
GT
• Twin 62 mm bore (stock Mustang GT is twin 55mm)
• Precision machined from billet aluminum to
ensure consistency
• Polished finish with machined Ford Racing Logo
• Tested to Ford original equipment specifications for cold
and hot weather
• Fully assembled, complete with throttle position sensor
and actuator motor, ready to bolt on!
• Use OE gears to prevent gear bind and wear common with
other aftermarket throttle bodies |
|
|
 |
2007-2010 MUSTANG SVT 4V IGNITION COIL
SET
M-12029-4V $295.95
• Fits 2007-2010 Mustang SVT 5.4L DOHC
• One engine set of stock replacement coils |
|
|
 |
2010 MUSTANG GT FORD RACING
PERFORMANCE CALIBRATION WITH HIGH-FLOW K&N AIR FILTER
M-9603-MGT $410
• Fits 2010 Mustang GT with automatic or manual
transmission
• Approximate increase of 9hp/up to 4 lb-ft over
stock
• Kit
Includes:
Ford Racing ProCal tool with
performance calibration for significantly improved throttle response
and performance feel
2010 Mustang GT High-Flow K&N/Ford
Racing Air Filter |
|
|
 |
2010 MUSTANG GT HIGH-FLOW K&N/FORD AIR FILTER
M-9601-MGT $74.00
• Fits 2010 Mustang GT airbox
• Flows approximately 22% more than stock filter
at 1.5" H2O delta pressure
• K&N 4-ply panel washable air filter
• Co-engineered by K&N and Ford Racing |
|
|
 |
MUSTANG COLD AIR TUNER KIT (CALIBRATION
REQUIRED)
M-9603-M463 Fits 2005-10 Mustang GT
$295
M-9603-M40 Fits 2005-10
Mustang V6 $240
• Designed for those who want the Ford Racing
cold air intake for aftermarket performance tuning/calibration
• Ford Racing cold air kit utilizes
production-quality components which mount in the stock location.
|
|
|
 |
AIR FILTER ELEMENT
M-9601-C** $69.95
• Service replacement air filter for
M-9603-GT06 Cold Air Kit |
|
|
|
|
|
|
